Bumper for Hook and Keeper Door Holder - Polar White

Video Transcript for Review of JR Products Enclosed Trailer Parts - Door Bumper - 37210685

Hey everyone. I'm Ellen here at etrailer.com and where do we take a quick look at the door bumper for your keeper and latch. So this is going to help be something there to kind of stop that door from going open too far and causing damage to the inside of your RV or the outside as well. So it's just going to be this plastic piece, it does come with the hardware to attach it. So let's take a closer look at it and make sure that this is the right fit for your application.So, as I mentioned, it's made out of a durable plastic, so it's going to be a hard material. The mounting screws just go right down in to attach it either externally or internally for your RV.

So if you already had one and you're wanting to replace your bumper, there should be a good fit. So take some measurements, to make sure that this is the right size. So overall it's about one and five eighths inch across, and then about one and a quarter inch tall, and just about five eights of an inch thick. The distance between the mounting holes center to center, roughly an inch, maybe an inch and or 15 sixteenths if we want to get really technical, the screws measure about an inch and a half in length.It is covered by a limited lifetime warranty. And that about does it for our look at the bumper for your hook and keeper door holder.

I hope this has been helpful in deciding if this is going to be the right piece for you. We do have a lot of other door and RV accessories in general here at etrailer.com. So check them out. Thanks for watching.